Posted by The tractor vet on November 07, 2019 at 08:51:32 from (104.179.81.68):
In Reply to: Re: Flooded basement. posted by Frank 41 on November 06, 2019 at 18:08:59:
That's a crock . If the basement was done correctly then one should not have to worry about it . BUT on oold houses with cut sand stone foundation or one that was not done correctly then ya may have a water problem , if you set low or built on a wet weather spring , hill side you may have a wet basement . proper drainage is the key and having the floor slope to a common drain is a good idea . Sump pumps are only good when they can keep up with the incoming water and you have POWER to keep them running . I deal with a WET basement all the time as i have everything going against me , living on a hill , cut sand stone foundation , wet weather springs , run off that can get so bad that at times there is 8-10 inches of water running down the drive next to the house , now as long as the floor drain that is a little over 120 years old is open we get a little water on the floor . BUT let that drain get plugged with tree roots then it can get deep like waist deep as it has three times now in the thirty years we have been here . If i was twenty years younger and the OLD guys were still alive i would fix this problem with a new foundation and way better drainage. The ones that would come in and jack a home up are all dead and gone and nobody around here does that stuff anymore . There equipment and iron all went to scrap . But as for me i will keep a basement under a house . Makes fixen a leaking water pipe or sewer way easer then busten up concrete makes it a lot easer thawing a frozen pipe and stepping on a good old fashioned wood floor a lot warmer in the winter then a cold slab of concrete.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
