Fantastic! Thanks for the welcome, the offer for the parts, and the better location for my post. I'm not sure how I missed the Ford forum. My view must have been blocked by my colon. LOL.
I had no idea these engines were initially designed as diesels. Very interesting! That would help explain these fittings. I found a nut that I think would work, in an Eaton catalog. It's called a diesel nut! It's for 5/16 tube and has a 5/8-18 thread (part number 8112x5). Measuring the male compression/rubber seal fitting, I'm thinking it's the right size, but can't be sure without having one in my hands.
Yes, the fuel lines are all over the place! Fortunately, I have a little experience with figuring out how to route pipe (or in this case tube) from my time as an HT in the Navy. GO NAVY!
As Steve suggested, although before he suggested it, I routed the lines away from anything hot to reduce the chances of vapor lock. Fortunately, some of the tube from the tank to pump was still attached to the tractor so all I had to do was plumb from the tank shutoff to the remnants of tube to the pump. Then from the pump down to the bolster, across the timing cover, and back to where I'm placing the sediment bowl. A lot of measuring and bending, but it was a lot of fun! At least until I got to the fitting I can't identify.
I will certainly take you up on the offer for the fittings and tube. I don't really need the tube, especially since I probably don't have the sediment bowl in the same place as the factory. But I'll take it because I may bend some new lines to bring it closer to original routing.
I'll hit you up with a PM to coordinate for the parts. Thanks again.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.