Those 3 cylunder gassers did take a rather circuitous route from the tank to the carb didn't they. But those engines were first designed to be diesel and kind of as an afterthought made to run on gas. About the only place to put the fuel pump on them was on the timing cover so that's what they did. I think the threads that go into the sediment bowl and into the carb are 1/8" NPT. The other end is like a compression fitting that uses a rubber ferrule inside the nut. About the only place I've ever seen them is on these Fords. I do have a pair of those fittings here that I would give you free if you want to pay the shipping. Would throw in the correct inlet pipe that loops around the throttle and governor rods too if you wanted it. Same price. The fittings would go in a $7.50 Flat Rate box. If you wanted the pipe too it would have to go into the next size larger box $12? $15? Those 3 cylinder Fords are my favorite tractors. I have 3 of them. But I got tired if dinking with carbs and points so mine are all diesels now. By the way, welcome to YT. There is a very good Ford Board here. Bunch of knowlegable guys there. I would post your Ford questions there instead of here. Email me with your contact info if you want these.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
