Tractor Talk Discussion Board |
Power steering for Farmall Super M.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glenn Thoming on June 12, 2007 at 07:03:35 from (67.43.252.51):
I’m planning to install a Char-Lynn steering valve on my Farmall Super M. Model SM, Serial # F-32828-J. The M has a bucket on the front and an aftermarket 3-point hitch on the rear. They both work at the same time and the hitch is power-down too. My problem is that I’m not sure how to connect the steering torque generator into the hydraulic system. There are no hoses connected to the left side of the engine. Those two points have the small round plates covering the openings. It has been suggested that the motor be connected in series with the loader control valve. The steering valve is “open center” but would it restrict the flow to the loader too much. This is my first venture into hydraulics.
Replies:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|