Tractor Talk Discussion Board |
Re: converting 8n from 6 volts to 12 volts
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Gerald on December 07, 1998 at 07:59:23:
In Reply to: converting 8n from 6 volts to 12 volts posted by Jim on December 06, 1998 at 21:55:26:
: I am trying to convert my 8n to 12 volts. I have found a 12 volt alt. from a Gm. The mounting bracket from an old buick v-8 Fit with a few modafications. My problem is the pulley on the GM. alt. is smaller in width than the pulley on the stock generator. Will this cause a proble with the belt ? Do I need to change the pulley or do I use a different belt? Any help here would be wonderfull. Thank you in advance Jim aka Wilseya. : You can e mail me at lybarger@thegrid.net : Thanks again and Wilseya The V-belt has to fit all pulleys or it will be destroyed and won't work while its being destroyed. You probably can't use the old generator pulley on the alternator because the alternator needs to turn faster and the tractor already runs slower than a car engine. Its a lot easier to change the new alternator's pulley than to change the crankshaft and water pump pulleys. You may have to visit a machine shop and have a custom pulley made to match the width and angle of the ford pulley but the diameter of the standard alternator pulley. You might be able to separate the halves of the alternator pulley with washers, if the shaft is long enough. Gerald
Follow Ups:
Post a Followup
|