Tractor Talk Discussion Board |
Re: Farmall A model Throttle linkage.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on November 26, 2001 at 15:30:48 from (128.59.6.157):
In Reply to: Farmall A model Throttle linkage. posted by Herman on November 26, 2001 at 14:26:37:
Did this come up suddenly, like without changing anything? i.e. did it run and something has broken, or has it been worked on and and not got put back right. Does it run? If so, fast or slow? If the throw on the throttle lever is good from low to high throttle, I'd look first at the linkage on the carb side. Disconnect the turnbuckle from the governor rock shaft and check the adjustment. With the throttle lever back at the seat all the way forward (full throttle), push both the governor rockshaft and the rod linking it to the throttle lever on the carb as far back as they will go, the turnbuckle should be adjusted to line up so that the link pin slides right back into the governor rockshaft. Hope this helps. Let us know how you make out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|