Posted by big tee on April 12, 2019 at 06:00:43 from (199.120.66.180):
We had a lot of snow this winter and besides our own I pushed for my buddy who broke his ankle so the pipe edge I put on my bucket was wearing out. I built it out of a piece of pipe from the carriage of a Mayrath auger I junked out. It was not real thick wall and the ends were wore out. I was going to cut the mounting tabs off and flip it over and weld them on the other side but decided different. I took a wore soil saver disc blade and took my plasma and cut wear strips out of them. They are thicker in the middle so they followed the wear pattern of the pipe. I then welded them to the worn ends and ran beads to the rest of the pipe. Of course it warped but with the help of a ratchet strap and a big hammer I got it back on. It is not pretty but it was cheap. Have not used it yet and hope I don't for I hope winter is over in N.E Iowa!!!---Tee
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.