Posted by VicS on July 02, 2018 at 13:08:44 from (174.255.5.214):
In Reply to: Kubota M135GX posted by THORNHILL on July 01, 2018 at 21:00:19:
We have a 126Gx. It is our main tillage tractor. Replaced a 4040JD. Pulls a 12x23 White no-till planter. 15 ft do-all. Just got done spraying beans. 1000 gal sprayer 60 ft booms. They have a lot of neat features. Like. Front wheels can be set to speed up in a turn. Makes it turn sharper than a two wheel drive. Can set how high 3 point lifts with a knob. And lowers. Then you can use a rocker switch. Throttle also just hit switch and motor slows to where throttle is set. Then hit again and speeds up where knob is set. Gov is electronic does not vary any. Also motor is a torque monster. Trans is 3 ranges. 8 powershift gears. Front axle is spur gears so axle is higher than center of wheels.and it doesn't jump when turned to lock.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.