Posted by Kingmopar on November 30, 2017 at 21:38:01 from (71.54.152.173):
In Reply to: Electronic ignition posted by Txpoweranger on November 29, 2017 at 08:07:23:
Put the Pertronix on my 53 Super A, along with an internal resisted coil and got rid of the ballast resistor...and I could tell the starting difference, right off the bat. Being a "Mopar" guy...there was always 2 things that you carried in your trunk back in my youth.... a spare Control Module which at the time was like 19 bucks at K-Mart, if you wanted the standard type(Not the Direct Connection HP unit, usually orange in color) and a ballast resistor. If your engine shut down...one of these, were normally the issue, especially if it rained and hit the ballast resistor. I did, have to adjust timing after the install to get rid of a bit of sputter at idle..a little advance..but now......2 turns..and it starts. Ebay cost to me...was like 63 bucks. Points be darned..unless...you are trying to be all OEM>..Just my opinon.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.