Posted by Billy NY on July 29, 2017 at 06:09:37 from (74.76.4.60):
Kind of falls in line with "drivers today". It's appalling whats on the road today in regard to drivers without an ounce of respect for anyone.
On the way to the job site yesterday morning, I came across another tractor trailer diagonally across a 2 lane road in a kind of a blind area. Broke down, but why across the road like that, have a few ideas, but what a thing to run up on without expecting it. Our tandem boom truck was not far behind me, but he can see further being up higher.
On the way out heading back to the office on 209 north of Ellenville, a young man in a red F350 just crosses the center lane, and narrowly and I mean narrowly avoids a head on with a fully loaded dump truck. Playing with his phone. I pulled over to the shoulder expecting the collision being right behind him. There was a tractor trailer behind me.
It's not you, it's definitely the other guy. The story in the attached link, I would have hit the car without hesitation and unfortunately a long time ago, did exactly that. Driver lived, rig did not get destroyed, scratched bumper is all.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
