Posted by Adirondack case guy on July 10, 2017 at 16:57:33 from (69.207.198.19):
I an in the process of reviving a Case G310G dozer after an engine fire. All the electrical components were destroyed with the exception of the starter. Radiator, oil bath air cleaner, fuel pump, and carb also destroyed. I have been able to acquire used distributer, and carb. Prior to the fire someone removed the generator and VR and just ran a 10G wire from the single stud alternator directly back to the bat box where they bolted in a 30A circuit breaker and then attached the leads to the positive post of the battery, which took the entire ignition switch and gauges out of the charge circuit. I asked the owner of the dozer to pick up new water temp, oil pressure and volt meter gauges. When he got delivery from the NAPA store they just sent him one of those 3 gauge assys. with an amp meter. They also substituted singe 0 bat cables verses the double 0 that I asked him to get, plus they put in those rotten clamp on battery ends when the list clearly said swedge/soder ends. I was not happy, but that is another story. Here lies my question. I want to bring the amp meter into the charge loop. It is a 60A gauge, and the alt. is rated for 63A maximum output. If I run the new 10G wire from the alt. to the pos. post on the ammeter, and then run the wire from the neg. terminal on ammeter down the starter solenoid terminal that the bat lead is connected to, will everything work??? Would you put the ignition switch into the charge circuit also??? Would you incorporate a 30A breaker into this charge circuit like before??? The only electrical load is the lighting system and the ignition circuit. Chances of the lights being user are slim. A simple volt meter would have been much better in my opinion, but I have to deal with what was brought to me. Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
