Posted by Pecan man on July 01, 2017 at 15:27:00 from (74.195.197.67):
The fuel injector pump and injectors were removed by independent mechanic, pump and injectors were reworked by a very trusty and long established repair facility.
Mechanic fell ill and has not be able to return to install pump and injectors. I took it upon myself to install pump and injectors. Mechanic did not place scribe marks on injector locking ring. Attempted to start tractor only smoke coming out of exhaust.
Removed injector pump and returned to repair facility to find when number one cylinder would get fuel. Reinstalled pump without locking ring, rotated cam shaft until piston number one was at top. That matched TDC on timing mark on front of engine. Manual states 10BTDC, rotated cam shaft to 10BTDC. Installed pump shaft lock ring. Engaged starter and bleed the lines up to injectors. Only colored smoke came out exhaust.
Loosened locking ring and rotated pump shaft in all three possible locations. Within each location engine was rotated in order to try and start engine. Never could get engine to start. Sprayed starting fluid into air intake and engine would run briefly.
Injector Pump is case part number 1329101C91.
What am I doing wrong? Also, what is purpose of o-ring on injectors?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
