Posted by Fatjay on April 18, 2017 at 08:16:47 from (173.49.59.155):
The steering shaft broke on my kubota b8200 when I took it out to clear snow a couple months ago. I've spent some time since then converting my tractor to power steering. There were no universal kits available so I had to start from the ground up.
My hydraulic block had a dedicated supply and return line for power steering already, so that part was easy. The rest I had to do on my own. It was a learning process, so now that I'm more familiar, my next conversion should be much easier.
I picked up a 5 port power steering block/column from a john deere 318. They were by far the most readily available and cheapest, at ~$150. I picked up a 14" hydraulic cylinder with 8" throw from surplus center. The rest was just hoses, which my local hydraluic shop made for me in various lengths.
I took the old system out, which had the standard arm that went back and forth. Gas tank off gave me plenty of room to work.
The hydraulic flow is a bit higher than it was on the deere I guess, because it only takes a half turn of the steering wheel to go all the way left or right. Still, it's effortless one finger steering.
From now on if a tractor's steering gives me any issues I'm converting to power steering. Enough of the aching elbows from working a wheel around manually.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
