Posted by jcrogers on January 23, 2017 at 10:53:51 from (99.197.221.21):
This message is a reply to an archived post by Dieseltech on September 22, 2016 at 21:48:20. The original subject was "Re: Ford 5000 Simms Minimec control".
Yes, when the rack is stuck, you can free it up temporarily to get the tractor out of the way, but it will die again and the next time will be worse, etc. That is because there is a lot of grime and dirt inside the pump or the rack would not be stuck. The rack floats on a spring and that is why the throttle lever had no affect. I would recommend taking the pump out and strip it down on your bench to clean all the parts.
Alternatively, you can 1- drain the oil by removing the oil plug on the bottom 2- remove the side inspection plate 3-unscrew the allen screws on the top of the delivery valve cap and remove the rectangular piece being careful not to lose the springs. 4- put a pan under the pump and flush the unit with solvent over and over again from the top & side until all the parts are clean inside. 5- reassemble.
When you remove the delivery valve, the springs and the plungers may come off with it, because the plunger rods may be stuck in the delivery valve barrels. You can put them on your workbench and take them apart to clean them. just remember that the little foot at the bottom of each delivery valve plunger fits into an opening in the rack. You can see these feet placed in the rack when you first take the side plate off.
I would not use brake cleaner, except maybe on the delivery valve parts, because it can dissolve O-rings. Your unit may start leaking when you get it back together.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
