Posted by farmall706guy on December 20, 2016 at 13:44:31 from (50.108.105.170):
I am in an emergency situation, The last month, the weather has dropped, I have been holding down on my glow plugs 50 seconds to start the tractor, and i have not been giving them a 2 minute break, anyways, 5 glow plugs are shot. I tested them, some 90 Ohms, some not even making a connection. only 1 plug is doing 1 ohm. anyways, I know how to do everything, but I am so worried to try and start taking them out, because i know they bust really easy. I am begging for advice on how the Safest way is to remove them glow plugs, pretty much on the first try. they are probably as old as the tractor. 1966. I snow plow many peoples driveways. I already ordered a pack of 6 new plugs for it. I am too afraid to touch them without getting advice from this website. Any types of tips, advice, or anything i can do to get them out? I can't start it to bring it into a heated barn, so I'm out in 20 degree F. I'm not using either to get it into an pole barn, ether for an IDI is a no no. Any advice from anyone is useful. Thank you for any possible help...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.