Posted by Dave H (MI) on October 28, 2016 at 14:55:43 from (50.108.25.68):
Back in June of this year I asked for advice here on how to do a block retaining wall on the east end of my barn and received some really excellent responses. I watched some YouTube and read some websites also. Here is a picture of the finished wall...or nearly finished. Even though I liked it bare, I put some white paint on the outside which I expect to weather and peel and look rustic. Footing is well below frost at almost 4'. Rebar comes vertically out of the footing. The third course is a bond beam reinforced with rebar and tied into the verticles. Also tied into the bond beam are 6-7 horizontal rebar that go straight back into the soil 5' behind the wall. Each of those has a large concrete rectangle poured around the end of it that tie the wall into the backfill. Like a "dead man". Hope I did this right. If there are any glaring errors, just don't tell me. I will worry about it all winter. What's done is done. :)
In the background is the 820 combine head. Just got that on the combine and checked that it works. Behind that is what used to be the neighbors house. We bought them out a year ago. Got some great trees in the deal. I think that is Tom O'Conner'ss old truck back there on the drive...or my pickup...same color. Anyway, thanks for the advice. It was a great project and I was in better shape when I was done than I have been in years!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
