Posted by oldtanker on September 28, 2016 at 19:27:10 from (66.228.255.59):
In Reply to: Chopping corn (pic) posted by oldtanker on September 27, 2016 at 10:22:06:
Quoting Removed, click Modern View to see
You didn't add the value of your time, maintenance or depreciation of equipment. All that has to be added in too if you are really going to see if it pencils out. I doubt it will for someone doing 30 or so acres. But some of the dairies around here of 500 plus cow farms. Even for smaller operations that hires a couple of operators it may be cost effective to hire it out. Heck I was just reading that some of the big SPs can chop 340 or more TONS an hour! So I would guess fuel consumption would be based on tons per gallon. From a little research some of the big choppers are cutting 204 to 359 tons an hour and burning between 30 and 50 gallons an hour.
So take your 410 for fuel and add in the cost of yearly maintenance and lubes, depreciation replacement cost as stuff wears out and your time at a farm managers wages. Lot more complicated than just your fuel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
