Posted by D Slater on April 26, 2016 at 05:45:04 from (50.110.59.50):
In Reply to: Re: farmall 400 posted by pence2348 on April 26, 2016 at 04:00:46:
You say a lot of B codes? Serial number is a December 54 built tractor if a 400. On the left side of the center housing near where the clutch and T/A shaft enter housing you should find a Z code if a 400 housing with that serial number. If not a replacement block, down near oil pan and around top or just below the frame rail about center from front to rear you should find a block casting number. Most D-264 cast numbers end in R4. Early like your serial I think would end in R3. Late 400 or some replacement blocks end with R5. R5 was used in 450D also. Most R3 and R4 blocks have a date code between oil pan and coolant side covers toward rear of injection pump and kind of behind it. If you look at the right angle you can see it. Lots of R5 blocks have the date code near rear on the same side partly behind the fuel filters. Does the tractor have 6 spoke rear wheels or 8?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
