Posted by Don-Wi on March 20, 2016 at 22:09:36 from (66.87.76.61):
In Reply to: DMI clamp on duals posted by Rb4430 on March 20, 2016 at 17:38:32:
I'm guessing those are for the clamp bolts to hold it to the tractor's wheel. Ours are slightly different, but they all work on the same principal. All you do is clamp them to your wheels, the hook bolts are the means of drawing them tight. If you don't have them quite tight enough, the dial will soon a small amount inside the lip of your tractors rim, but that ultimately draws it in tighter. They're not liked by everyone, but they work just fine and usually can be had cheaper than bolt on duals. Also can be installed on tractors that have no other option for mounting duals, such as our Massey 285. The axle doesn't have a clamp on hub like row crop tractors do, so no way to have a hub for bolt on duals.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.