Posted by Zachary Hoyt on February 09, 2016 at 09:09:14 from (172.79.38.21):
I am hoping that someone wise will be able to tell me what I need to do to run a wire about 80 feet indoors to the new building to run a stick 'tombstone' welder out there. I got the 110 wiring done in December and that was no problem. The welder hookup is something new for me and I want to find out how to do it right so I don't tick off the electrons and cause a riot in there. I have four of these plugs that I got in a box lot at an auction at some point. They are marked 50 amp and look like they would fit the welder plug. They only have 3 connectors, so I am wondering if all I need is to run a 6/2 with ground cable like the one in the link on eBay out there and hook them up, the top two to the breaker poles and the bottom one to the neutral bar. If I need to I can buy 6/3 but I would rather save the money if I don't have a job for that fourth wire. Any advice will be much appreciated. Zach
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
