Many people get very confused by this, and so it is hard to depend upon Internet advice about wiring....
There were two or three good electricians that would post here, but I think they have all gone very low key the past few months, as they get overwhelmed with the 'just wire it up any old way so it works, that will be good enough' crowd that offers opinions on this topic......
The ground wire is there to protect you and to protect your wires and your buildings from bad things happening.
Many years ago they often kinda rolled the ground and the neutral into the same wire, or criss crossed them any old time.
After some thought on it, they realized that wasn't a good idea.
The neutral wire carries away electricity in 120v wiring. So that wire is actually live.
The ground wire is only there to protect you, and it is wired up to nearly every exposed metal surface anywhere in your building.
So, if you mix up and tie together the ground and the neutral wires, you end up potentially supplying live electricity to all your metal surfaces all over your building.
And heck that will work fine, so long as the wires don't fall apart. Because the ground wire will end up taking over and do the job for you.
Unless there is a problem....... You never know when a problem shows up.......
So, anyhow, you don't need a neutral wire here at all, so no big deal. Neutral is only for 120v stuff.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.