Posted by TXZane on December 11, 2015 at 18:57:34 from (166.137.118.80):
The other day at the lumberyard I work at a man walked in at about 11am. He asked for a 3' stick of moulding. (We only sell full or half lengths of moulding) I went out brought back in an 8' piece and said "This is the shortest piece I have, will this work?" He said "but I only want 3' of it". I said "Well sir we don't sell moulding less than 8' but I will cut it for you if you like." "Nope, see what else you have out there" he said. I went out, came back in with a couple different pieces that were about 5' and 6' but didn't match what he wanted. He said "thank you" and left, not taking anything. I knew then I really made him mad. I would have cut the moulding he wanted if he hadn't have left just so he wouldn't be mad. My boss then came over and said "good job buddy, you just ticked off the richest man in the county" jokingly. A few minutes later my boss left for lunch. I felt bad for making the guy mad. An hour later the same customer came back in, tooth pick in his mouth. I knew he had lunch with my boss. Me tried to avoid me but when he realized I was the only one that could help him he did the biggest eye roll I have ever seen. Then said "YOU GOT THAT MOULDING CUT AND READY TO GO FOR ME?" I said "no sir I don't". "Well I just talked to your boss and he said he called down here and told you I was coming to get my molding" I never took the call but I went and cut his moulding, took his money and smiled the whole time and said thank you at the end. He mad me fell like the smallest person in the world. Ok rant over.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
