That's just a rough mock up, its not nearly set to where it needs to be, which is even higher actually, but per cat 2 dimensions center to center, lift arm pins to top link pin.
I'll set the 2 uprights/posts with a mark across the tube for height, per my fab sketch where I worked out the details to get the 24" center to center vertically. I'll then clamp/match mark the flange holes, center punch, drill same, fasten, then I can set the width, with the brackets, then lay the top piece across and weld the top link flange.
The way its laid out, per the JD cat 2 diagram and others off the web that seem to match what JD had, it has the top link hole 24" center to center from the bottom lift pins, per the drawing, and they are in the same plane vertically, centered top to bottom at 24" It's possible I could rotate the angle down, adjust the height, but to maintain the holes in the same plane, I don't know if it will be an issue as I don't think I have adjustment that way with it orientated like you mentioned. I'd have to off set the top horizontal piece somehow. I do see the value in doing this, exactly like you said, to catch that top hook, its going to work better for sure.
As shown, I could live with hooking it up without the top pin installed and could reach it from the seat, then just pin it after the hook is in place.That kind of defeats the purpose but really not all that bad either seeing I can reach it from the seat. I have other implements that likely would be worse with the top link connection and a quick hitch.
I don't necessarily need the quick hitch, given I don't switch implements all that often, but it would seem to be real handy when you do, hence my consideration in this small build.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
