Posted by Mike M on October 28, 2015 at 13:38:29 from (24.140.3.210):
In Reply to: Re: Holder A55 Tractor posted by Holder A55 on October 28, 2015 at 12:53:47:
Spiral may be tricky. How big is it ? The larger it is I think the easier it would be to do yourself ? I have welded up JD rollomactic gear teeth which are straight cut without issue. You just have to get a rod made to weld on gears. Certainium 707 used to be a good one but is hard to find. Last time rod dealer crossed it to something else. These rods weld gets hard and has to be ground to shape. Also had a welder friend weld up some parts of a steering worm where the break the corners off of. He tig welded it with some hard stuff. Nice thing with tig was he could control better how much was laid down so not as much grinding needed. No special heat treating needed before or after welding these.
There is a guy on here I think Rich Dwane (sp?) makes worm gears for the John Deeres. Might be worth a shout out to him over at the JD board.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.