Posted by mtf on August 14, 2015 at 18:25:36 from (173.240.134.127):
In Reply to: Re: Cross bearing help posted by mattcatlin on August 14, 2015 at 17:51:14:
It is hard to tell, but it kind of looks like the side next to the nut is not seating properly, that will be the side with the bearing out of place. Removing is difficult. Drive both cups to one side as far as they will go, with large hammer and an impact socket. The part of the cup that sticks out past the yolk can be clamped in a GOOD vise with GOOD jaws and removed by rotating and prying. You will more than likely destroy it. I would replace it with a new one. Looks like a 35 series joint. I just bought some Made in USA for 35.00 last week. When you get it back apart measure to make sure cross is right size. I like to install joint in the 'heaviest' side first and easiest yolk side last. Some of these with cv's can be quit heavy and prone to finger pinching.
Also if you pressed with that much force you have distorted the bearing and put a flat side one it. Another reason to replace with new.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.