Posted by bison on June 24, 2015 at 22:45:38 from (69.168.144.140):
In Reply to: Why not metric ??? posted by JD Seller on June 24, 2015 at 21:47:38:
Canada went all metric in 79.
Blue prints are in MM only, carpenters build in feet and inches.
Till this day all lumber is still sold in standard sizes as is structural steel, bar stock and tubing
Finding metric bolts is a night mare, all bins in farm stores are filled with standard bolts and nuts,.. not a metric size in sight.
Metric sizes have to be ordered or one has to make a special trip to a bolt and bearing house and half the time they don't have them either.
This is madness :roll:
I grew up in a metric only country, today i am more comfortable using standard as everyone i know still uses that.
The only times i like using metric is with machining as i have a metric lathe and the decimal system for small tolerances is far superior to standard. This lathe can cut any tread known to man.
And for the same reason i use metric for weights smaller than an ounce.
There is nothing wrong with standard weights and measures
The whole country is laid out in miles and acres, to try convert that to metric does not work worth a damm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
