Posted by Texasmark1 on April 12, 2015 at 13:42:55 from (162.72.24.91):
In Reply to: Shop floor sealer posted by Alan K on April 12, 2015 at 11:48:22:
I went to the local big box store and got something for the job for my new shop at the time. Put it down as directed. Had plastic underlayment to control ground moisture.
In short it was a waste of time. So this time I still used the underlayment which works fine as long as you aren't going through a temperature change with high humidity.....floor and everything else sweats regardless....it's air temp and moisture, not dirt temp/moisture.
So my new shop floor looks like the old one. I usually have a spill every time I change the oil on something. Just happens with the best laid plans. I gave up on it and said ok there'll be a mess. I put the absorber on the mess and after it has done it's job the spot is not nearly as bad looking as I had anticipated. Besides, like anything else, once the new wears off who cares. Yeah I keep a tidy shop but there are limits and it IS a workplace.....mine is anyway.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.