Posted by lfure on January 25, 2015 at 06:52:56 from (68.169.254.14):
I posted this on the IH forum, but didn't get too many answers. I have a IH 340 utility with a Wagner loader on it. I changed the double spool loader control valve for one that had a float setting for the lift cylinders. The tractor has the internal hydraulic pump. The pump outlet is a 3/4" aluminum pipe, which has a large hose attached to it with a compression fitting. When I first tightened up the fitting I didn't have the right size wrench for the nut, so I had to improvise. Of course the fitting came loose when I was testing out the new valve. I purchased the right wrench and tightened the fitting again. So far it hasn't come loose, but I'm still worried about it. Would it be possible to flare an 3/4" aluminum pipe? Or should I just leave it alone and hope for the best?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.