Hi sounds like you had fun with those projects, That combine motor must of been a 2700 series from the U.K I would think. unless it was a newer series. From what i have been told with those transmissions they like good bearings and shimming correctly. The other key to it is if it has done heavy field work. they wear the splines off in the coupling between the gear box and rear axle. Guys say to go right through it and check everything while your there. The reason being is your that far in. if that shaft quits 3 weeks later your back again and probably scrapping the tractor. in 2002 I was told that shaft kit was something like $17.000 for a DX 120. Thats why I was pulling a used one out, that infact was junk on removal. it had twisted on the splines making everybody think it was good before we tore it apart. That shafts what happened to the 7.10 with my guy it lost drive in the field and jumping out of gear before that, but i know of a machine shop that did an update/ repair to it that saved a load of money. Not sure if they still do them though Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.