Posted by WellWorn on November 10, 2014 at 16:48:57 from (75.226.101.162):
In Reply to: First Tractor posted by marcusvandendaele on November 10, 2014 at 10:16:14:
I don't think the 8N fits the OP's basic requirement list: live PTO and hydraulics. The 9N is even worse with only a 3 speed, which makes for getting into trouble even faster.
My choice for a newbie with a brush hog would be the Massey 35/135/150 (with perhaps a IH 300 or 464 in second, with Ford 3000 in third place). I admit I'm partial to the Massey or IH over the Fords, as I've worked with and on all 3 (and others), and IMHO, the Reds of that era are better than the Blues. Just got done with another JD project that left me pretty sour on them (again).
The ones I've listed above have 3 (or 4) speed trany the Massey Ford or IH 464 with a hi/low, for 6 (or eight) forward and 2 reverse; live hydraulics and PTO. They will creep going through tall grass or over uncertain ground, and will allow operator response with raise or stop tractor motion without bringing EVERYTHING to a halt. With the 8N and others of it's era, putting in the clutch stops and drops the hog, when what was probably wanted was to stop forward motion and raise the hog but keep it running to clear the 'bog'. Brakes on the old Fords were notably bad as well, especially going backwards.
There should be lots of possibilities for these models in your price range. For occasional summer use only, a diesel would work well, but would probably cost more up front. For summer and winter use as well in the northern states, gas is probably a better choice as they start a lot easier when cold.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
