Good idea to create a load for these older workhorses since so few of us plow (plough) anymore or have free access to a dyno.
A 6' rotary cutter would be a good load on an ole Farmall h even with mower adjusted perfectly. Purposely misadjusting the mower served your purpose of creating even more additional load quite well.
I have used my ole Farmall h with only a 5' rotary cutter mowing stuff that was taller then the exhaust pipe and it was indeed quite the load. Blew lots of carbon out that day. (Pretty sure my face ended up wearing some of it too -LOL).
Nice pic NEKS: I have also used my ole h on the Hesston 1120 mower conditioner (9' 3" haybine type machine) and it also gives it a very good workout but not overly severe like the bushog did in stuff that was extremely tall.
This post was edited by rankrank1 at 09:02:49 09/27/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.