Posted by greglinda on July 16, 2014 at 13:25:15 from (70.88.102.125):
Ok followed the advice on this forum got new lights hooked up. Replace everything. Found good grounds everywhere no problem. Rewired switch as it was. Apparently the ammeter was wire to the light switch. Is this standard? when I run the tractor w/o lights on the ammeter is at zero, when I turn on the lights the needle moves to +10 and stays there until I turn off the lights. !0 amps is about right for the lights I installed headlights have a in line fuse rated 15 amps and tail lights have a inline fuse 15 amps as well. Question: am I doing any harm to the tractor, ammeter, battery or generator by running it this way? On advise from the forum I did not wire to the keyed starting switch so I have to remember to shut the lights off. Everything seems to be fine just wondering if I did this wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.