Posted by Bobl1958 on June 20, 2014 at 08:56:57 from (68.98.205.31):
I am pretty sure I remember that you are running the Gehl balers. I have a 1875 with the Gehl monitor that sets the bale size and the wraps, etc. My question is, if you happen to have the same setup, is that the size of the bale on the monitor is not working. It is the bar graph that starts at 0 and climbs up as the bale gets bigger. And since it is not working, it won't alert me when the bale size is complete and start the tying phase. I have to manually push the button to tie. It will then tie the bale automatically and go back to "ready to bale mode" and then to start the procedure again. Last year when I blew everything off and put it in the shed everything was working fine. Just curious if you would have any ideas where to start. The book doesn't give any good info regarding the bale size. I can set the size of the bale with the monitor, just the size as it is building is not working. I can try to get some pics if you needed, but if you have the same setup (even though you have a smaller baler I seem to remember) I am hoping you might know something. It's probably in the Electronics somewhere, but I don't see anything that would look out of the ordinary. Thanks in advance - Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.