Posted by tomstractorsandtoys on March 21, 2014 at 16:27:07 from (64.136.27.163):
In Reply to: IH 990 Haybine posted by fixerupper on March 21, 2014 at 07:33:47:
The 990 was a great machine. Dad had two seven ft machines years ago and we made 20,000 small squares a year.We replaced the knife each year and greased them each morning.Do check the rolls and if it has the metal spirals make sure no metal is missing.Neighbor was mowing and a piece of the steel off the roll came loose and hit him in the head causing him to need stiches.Some machines has two rubber rolls and some had one steel and one rubber.We sold ours and went to NH machines because we felt the intermeshing rolls on the Nh helped to dry the hay faster.We needed perfect hay because most of our market was horse people.We never had any repairs other than normal wear parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.