Posted by Bryce Frazier on February 11, 2014 at 06:55:36 from (67.142.182.21):
Good Morning. Many of you are probably on your 4th cup by now, but here in North ID, I, Bryce Frazier, am just getting my tired @$$ out of bed! Many of you know that I do all of my schooling through IDVA (Idaho Virtual Academy) and that is the reason why you are all plagued with me on here all day. :) BUT while only doing school for 3 hours, and then working in the shop all day may sound good, there are days, like today, where it sucks!!! Yesterday, I couldn't get into any of my classes with my teachers, so I had to just do my normal lessons, and then be done for the day. (Thats my usual routine) Today, I STILL can't get into any of my classes, and when I try to access my courses it says error -1??? So, looks like a snow day! woohoo.... Sorry this was pretty far off topic, kind of looks like a rant? To get it back towards topic though, I found those numbers for the Shares I need for my Case Plow. Grand Detour AB 140 share, and DX14 Moldboards. THANKS for listening, or reading for that matter! Bryce
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.