Posted by welled on December 22, 2013 at 18:09:16 from (69.168.250.166):
In Reply to: OT geothermal problems posted by Bradiniowa on December 21, 2013 at 17:28:19:
Been looking at the responses to your post and have to add my experience. Sorry for the length. We have used Geothermal for 13 years in our home in north central Minnesota. We heat and cool about 4800 square feet plus keep our garage at about 45 degrees all winter. We do have a propane backup, but have not fired it in the last 10 years. We heat and cool with Geothermal only. In 2012 out total energy cost for heating and cooling was $550.00 or about $45 a month. I do have the heat pump metered separately to accurately track costs and most years our costs are between $400 and $500. We use a combination of radiant floor heat and forced air. 115 degree water temp is normal. We did modify the system to have the bathroom heated any time any other zone is calling for heat and our installer did add additional capacity for the bathroom. We did the same thing for the entry door floor. Boots are always nice and warm. I have to clarify that our house was designed and constructed for energy efficiency. Payback for the additional costs was about 4 years.
Regarding your questions, I would go back to your installer. I am not sure what is happening, but something is clearly wrong. Geothermal IMHO is the only way to heat and cool.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
