These transmissions are controlled by the powertrain PCM. They have no capability for range selection other than the selector lever. That is, there is no governor or other mechanism for mechanically regulating operating range. NOW, having said that, the basics are that the trans has sensors reading input and output speeds. This is how the PCM determines what range the trans is in. There are also a number of pressure sensors on the valve body that relay info to the PCM as to which hydraulic circuits are pressurized. Failure to shift into 3rd can be caused by solenoid failures as well as mechanical failures within the trans. To isolate which is the problem, I would start with a scan tool and see what transmission codes are stored - there will most likely be at least one trans related code. If the code indicates an incorrect gear ratio such as "incorrect 3rd gear ratio," it would point to an internal mechanical failure. If you have a solenoid failure, it would indicate that as a different code that would translate to a solenoid failure. Today's electronically controlled transmissions are not terribly difficult to diagnose, but do require at least a minimal scan tool. I have been rebuilding /repairing automatic transmissions for over 40 years. I do not know the exact powerflow in this unit, but it is likely similar to the 4L60/4L65 units.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.