Posted by Dave from MN on September 14, 2013 at 08:31:25 from (198.98.195.73):
Have 2 newly aquired farms that, after excavating plots, have discovered they have serious hard pan issues, which explains alot of the variance from soil potential to actual yeilds and crop stress issues. Some as shallow as 4" down and 2-13" thick, other areas 8" down and up to a foot or more thick. Super, super hard. After coring we actually found moisture and loose subsoil. NRCS and agronimist say tillage radishes nor alot of slow rains will even be able to get through it. Soils spring mold board plowed for decades, and then last couple years previos renter hit with Wishek disk, in very wet springs. SI I am gonna buy a decent but economical ripper Looking at a 5 shank Tebbon DT5-30 and a Kewanee 2500 5 shank 30". Is there a better of the two? Will a 180-200hp 4WD be ok with it, as in places have to go deep. Plan is to rip, spread manure, disk or chisle in about 4-6" and plant Trytical all within the same week. Any opinions or advice. Is lighter soils, no issues of yellow clay found dwn there yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
