You've already heard there is no one correct answer. Depends on your friendship.
This afternoon I gave my retired machinist buddy a ride for errands in town. The traffic is more than he wants to drive in any more. We quit trading dollars a long time ago. He makes parts for me, I do whatever I can to help him out. Last thing was setting up his generator for emergency use. He doesn't know an amp from a volt.
Today he decided I was buying too much gas, or something, chauffeuring him and told me he wasn't going to use his circular sawmill again and that if I wanted to move it, I was welcome to it. Complete with two power units, hydraulic and belt.
Just clear the air. If you are friends it will be easy. I now have to decide where I'm going to set up a sawmill. And take him a couple of 4' lengths of pvc pipe tomorrow.
Anybody need an ancient 18" wood planer, originally driven by jack shaft? I do not. He knew that, and will sell it for scrap. Probably comes with the trailer it's sitting on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.