I don't remember what kind of tractors you have but you can just run it off of your hydraulics on your tractor, but when we did ours we put a return hose from the drain plug of the tractor with a break away on it to plug the pump return into. The oil must return below oil level. If I remember right you just change that hydraulic fitting from a tapered fitting to pipe thread to hook a hose onto. We run a 1466 or 1586 international on our 800 8 row and we have to shut the fan off at the end of the fied to raise the planter, turn around, turn fan back on lower planter and go. You just need to remember to lower the planter a bit earlier because the drum has to reload again. If your tractor has good pressure you may be able to leave the fan on and raise the planter. If your tractor flows too much oil you may have to put a flow valve on your planter hose to regulate air pressure, or if your tractor has a flow control adjust it accordingly to give the right amount of pressure on the ounces gauge.
VERY IMPORTANT! YOU MUST MAKE SURE YOUR RETURN HOSE IS PROPERLY PLUGGED IN OR IT WILL BLOW THE HOSE OFF BY THE ORBIT MOTOR AND EMPTY OUT YOUR TRACTOR HYDRAULICS QUICKLY AS SOON AS FAN IS TURNED ON, don't ask me how i know.
One other thing to check is your pop rivets that hold the hopper together. I had one pop rivet come out and I had trouble holding much over 5 ounces of pressure. One rivet will let the hopper split enough to lose a lot of air.
One other year the orbit motor that runs the fan went bad too and we were unable to build pressure. I tried one from the salvage yard, but that wasn't much better, ended up shelling out 400 for a new one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.