John B. said: (quoted from post at 21:22:51 06/02/13) A 2 1/2 day Gun Safety Class is required to get a F.O.I.D. card. I think this law for the safety class went into effect in 1978 I believe.
There is no state required safety course for a F.O.I.D application. A "Hunter Safety Course" is required to obtain a hunting license.
Our FOID isn't as expensive as Massachusetts Gun License: "Massachusetts residents 15 years and older who wish to possess, carry, transport firearms, ammunition and feeding devices are required to have a firearms license." "The fee for an FID card is $100.00 for people >18 years old and $25 for minors. It is valid for 6 years." Plus you have to pay for a "Training Course". The people in Mass. can thank Gov. Romney for signing their law.
This post was edited by spacecadet9 at 00:40:09 06/03/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.