Posted by Billy NY on May 23, 2013 at 06:25:37 from (72.226.79.200):
In Reply to: OT-OOPS! posted by omahagreg on May 22, 2013 at 16:26:38:
Thats why a shop drawing is created and submitted for approval or a door schedule is on the prints, I have found that these thigns don't check themselves, often times its so simple and over looked, and sometimes its easier to fix the R.O. might be a days labor but at least its done. Hate when it happens.
I had a 57 unit mid rise, apt entry doors, were ordered and approved off the architectural prints, owner decided towards the end to add a layer of underlayment over the concrete plank, which also had a level coat and a flowable grout coat prior to that, was too much what he added and all 57 had to be modified or re-ordered, thats why an approved finish schedule is supposed to be created, unreal, same developer, his next PM, I left by then, on a 40 story job, they ended up with the wrong size windows, LOL, there are ways to avoid this, I usually mark RO's on drawings noting they are correct, any that are not, someone gets notified, anything that gets ordered has to get approval first and is checked against the drawings, A/E should do this when the drawings or product data is submitted but I always review them myself, and even then there are times when something gets past, not much but it is part of the game.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
