Posted by Banditfarmer on May 03, 2013 at 15:48:40 from (174.103.154.185):
Well after a lot of lookin and figuring and cutting the multaflora rose bushes, I got to cutting it down. The first pic shows a better look how the tree grew and the following slows how tall and how it was leaning that was on my mind while starting to cut it. I notched it (looking at the tree) to the right side about 2 feet up and 10 inches in. Now I hoped what would happen was it gose over slowly hits the big limb and roles over to the left. At least I hoped it would. As I started the back cut at an angle to the notch, About 1/3 of the way cut it started to pop! Time to beat feet and get out of the way! Pop Pop and it slowly starts going over, I mean slow! Right down on the big limb and slowly rolled over to the left without hardly making a sound. I was so glad it went over slowly and didn't kick back or come sideways at me like the one did yesterday. My chain saw has a 32 inch bar in it and just went through that big limb when I cut it off. Hard part over now its time to cut it up into pieces to move it with the loader so it can be cut up at a later date. I am sure glad have 2 saws to use the big one will ware you out in the sun. I think it took longer to pile the brush up than it did to cut it down and up. The stump and butt of the log aint pretty, But its all said and done now, And no broken bones or injuries! Not bad for 4 hours of work. Maybe I will cut a dead one tomorrow? Bandit
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
