I have a 7 shank Hoeme and it is a dream. I think the factory was in Amarillo, TX.
What I like about it is that the tongue is long enough that you can get the plow to work this black gunbo (when wet) when dry and it just hangs in there. It is not spring loaded; it has shear pins and I like that because it is forced to dig, not give way when doing it's jub.
I have tried the kind you see pictured by Mr. Howell, but he is in sandy loam and I'm not and they just bounce across the ground due to no tongue here. However, for cultivation of already plowed soil they will work here.
I don't have sweeps on it, I have chisels, about 2" wide and bury them around 6 -8" when the soil is right. It gets below the hard pan built up by discing and cultivators (sweeps on another plow) cultivating. I pull it with a 57 PTO tractor in mid gear and reduced rpm. I don't pull it fast as I want to give the soil time to work for me, not against me.
I leave the soil dug up through the winter to pulverize it and to capture any rain available.
I personally don't think they would do much good in sand as I'd assume you have no hardpan to breakup.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
