I'm not going to say the US should fully adopt the metric system. Though Canada is technically metric, it still isn't in full use. Every construction material is still SAE. Most still use MPG. I'd say more people know their height in SAE than metric, same goes for weight. It was technically adopted in 1970-71. That said it is, in most ways, a superior system, that is easier to use and should save time once people understand it. EVERYTHING is measured in MM. CM is not used at all. Really hard to screw that up. Machining also uses tighter tolerance, as tight as 1/1000MM or 1/25,400inch.I've always wondered about 2L pop. Why isn't it in fl.oz.? I'll give you a quick lesson on metrics. 1ml(1CC) of water weighs 1 gram. 1 litre of water weighs 1kg. 1cubic meter of water weighs 1 tonne. A litre of water takes up 1000CM3 meter=100cm=10mm 1cu.in.=16.39CC 1OZ=29.57ML 1kg=2.204lbs 1tonne=1000kg=2204lbs. 1inch=2.54cm=25.4mm. 1meter=3.28feet=39.37inch 1 hectare=1000M3=2.47acres
If I were to try pushing anything onto the US, it'd be universal healthcare. Forget the metric system. The US would benefit from healthcare way more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.