Posted by Texasmark1 on February 16, 2013 at 05:43:57 from (198.45.243.137):
In Reply to: Wix filters ok to use? posted by johndeeregreen on February 15, 2013 at 18:02:17:
You are after 3 things with a filter:
1. It will stay intact and secured during the operational period.
2. It will trap particulate matter
3. It will allow bypass filtration if clogged.
You can pull up most any filter on the www and find out:
Mounting dimensions, threads and overall volume
Minimum filtration particle size trapped
Pressure release value of pop off valve.
Sometimes features are also added such as materials from which seals are made.
I just did a personal study of Fram mid priced, Wix and Delco. I took filters that all had been in-service in my p/u or my diesel tractor for at least a year. I dissected them looking for construction technique and integrity after having been in service for that period.
All were intact including the Fram that gets whacked for using a compostie paper for support members where others used metal. None of the paper support elements were distorted, nor were any of the glued joints defective.
On JD filters, JD doesn't make filters, nor bearings, nor belts, etc. They buy them from an approved manufacturer. Once you know the dimensions, filtration minimum, and popoff value you can shop for a replacement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.