Posted by JayinNY on December 03, 2012 at 17:53:06 from (166.137.89.161):
Last fall I hired my bil to plumb in a wood boiler, with my oil boiler. He made changes to the original system which was out dated, such as ball valves in place of the water spigot kind, made it easier to bleed air out ect. Last December it took me awhile to get the air out of the second floor baseboard, finally got it out, nice and quiet. This November I fired up the wood stove and I see the extrol expansion tank had a slight leak! Put a new one in 12 years ago. So I replace that, and get air in the system, even though I isolated it off with the valves. Bled system again, and seemed to be quiet, I go down to load wood last knight, and I see a sweat fitting developed a drip on the back of the stove. Well thank god for the valves and the unions, took it off and re sweat the pipe, put it back together and no leak! I hope that's it for problems! At least it was 52 degrees today so I could let stove go out, and my bil is a union pipe fitter for GE, so I could have called him to do it if needed!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.