one other thing ,theres no such thing actually as "DAMASCUS TWIST"..damascus barrels were made by taking a fine wire, beating it flat over a mandral and soldering it together to make a tube. twist barrels were made by taking a flat piece of stock spiraling it up the mandral and soldering the joint. if your barrels say anything "twist" thats the way its made. these were the weakest of barrels and the ones most likely to fail.the problem was not the steel, but the solder between the joints was weak,real damascus barrels were made up of many layers overlapping so the solder joints are much stronger than twist.the difference in a twist barrel and true damascus is daylight and dark. if you pick up a shotgun and you see a spiral going up the barrels,its a twist barrel,regardless of how its marked. true damascus wont show a spiral,and in fact its very hard to see the joints on a good damascus barrel. everyone liked to mark their barrels damascus,simply because it was a mark of quality. It was not the mark of a lesser grade in any way,but the mark of the best.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.