Posted by Brad Buchanan on October 10, 2012 at 21:08:54 from (74.71.185.165):
In Reply to: Crooked auctioneer posted by Steve terplak on October 10, 2012 at 17:07:27:
That is kinda interesting...
I leased an S-10 in '97 from an upstate NY dealer. Brand new had I think 7 miles on it.
It was a pretty good truck for real light duty as 6 bags of groceries would make it sag in the rear.
The lease was ending and I decided to buy the truck. It was nearing the 40.000 mile mark and was coming off warranty and I took it in to the dealer because the engine was getting loud (as in knock-clatter.
The service manager (dealers son) said that that engine had head clearance problems and they would fix it in a day.
He called me the next day and told me they were ordering a long block for the truck and to pick up a loaner car.
I got the truck back (ran great) and about a year later I was putting a receiver on it and found the trailer pigtail cut off with sides and stuffed into the frame member.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.