I have been irrigating my orchard until I get my well hooked up and after some experimentation I came up with the following:
2 55 gal plastic barrels on my 2 wheel trailer along with a 1000 watt 2 stroke generator that I paid about $125 for, a submersible sump pump with float switch and a 50 foot 5/8 hose.
I just put the pump, hose and power cord in one of the barrels (tops are removed) and fire up the generator.
With the hose on the level with the trailer it will empty the barrel in about 15 minutes. if you had a 2" hose on the output I imagine it would be several times faster.
I think the pump is a 1/2 horse.
And before I am savaged by the Deerman or the T-guy the generator is not grounded to the trailer, no ground rods were pounded t into the earth and there is no equipment ground.
I jes dragged the rubber hose around and when done killed the gen.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.